The APR MS100142 Billet Stainless Steel Dogbone / Subframe Mount Insert fills the gaps on the factory rubber mount to limit driveline movement and minimize wheel-hop and torque steer. This provides a more direct driving experience by eliminating slop in the driveline without introducing excessive or uncomfortable vibration and noise. Other mounts can deform or crack under use, but unlike all other units created from rubber, polyurethane, and even billet-aluminum, the billet stainless APR unit will not heavily deform to the point of failure and packs a limited lifetime warranty against cracking! There are two different configurations depending on the style of your factory mount so be sure to check your mount design before purchase!
APR MS100142 Dogbone Mount Insert Vehicle Fitment:
Note: Please refer to the fitment guide image to determine if your car requires the Version 1 style mount or the Version 2 style mount.
APR Dogbone Insert Manufacturing: The APR Dogbone Insert is CNC machined from billet stainless steel.
APR Dogbone Insert Install: Installation of the APR Dogbone Mount Insert typically takes around 30 minutes and is completely reversible. Remember to always replace the factory 1-time use stretch bolt! APR MS100142 install instructions.